Difference between revisions of "VTube-LASER v1.59"

From ATTWiki
Jump to: navigation, search
 
(→‎25px REPAIR: Mix ball probe and laser measurement)
Line 22: Line 22:
 
<td width=300>
 
<td width=300>
 
[[image:vtube-laser_ballprobe_endscan.jpg|300px]]
 
[[image:vtube-laser_ballprobe_endscan.jpg|300px]]
−
</td>
 
−
</tr>
 
−
</table>
 
−
<table cellpadding=10>
 
−
<tr valign=top>
 
−
<td width=500>
 
−
The new Construct Tube Control (shown above) allows you to point to any location in space to designate an end point or an intersection point.  It also allows you to increase the number of straights/points on-the-fly.  This allows operators to change the number of points at any time during the measurement process.
 
−
</td>
 
−
<td width=300>
 
 
</td>
 
</td>
 
</tr>
 
</tr>
Line 36: Line 27:
  
 
<br><br>
 
<br><br>
−
 
  
 
===[[image:Check.jpg|25px]] Issues with this version fixed in next version===
 
===[[image:Check.jpg|25px]] Issues with this version fixed in next version===

Revision as of 21:50, 5 February 2011

Vtube-laser logo.jpg

Revision 1.59

Back to VTube-LASER

Vtube-laser 1 57.jpg


Check.jpg REPAIR: Mix ball probe and laser measurement

Using ball probe measurements on the end scans and and laser measurements in the cylinder straights now offsets the ball radius point properly in every case.

Vtube-laser ballprobe endscan.jpg



Check.jpg Issues with this version fixed in next version

  • No known issues

Other Pages

Retrieved from "http://www.advancedtubular.wiki/index.php?title=VTube-LASER_v1.59&oldid=15905"