Difference between revisions of "Mandrel Lube"
(→Press AutoBuild To Make the Changes Take Effect in CNC Processor) |
(→Press AutoBuild To Make the Changes Take Effect in CNC Processor) |
||
| Line 71: | Line 71: | ||
<td> | <td> | ||
[[image:autobuild.jpg|400px]] | [[image:autobuild.jpg|400px]] | ||
| + | </td> | ||
| + | </tr> | ||
| + | </table> | ||
| + | |||
| + | |||
| + | ==Sample Settings and the Results== | ||
| + | |||
| + | <table> | ||
| + | <tr> | ||
| + | <td width=300> | ||
| + | If... | ||
| + | * the bend angle is 50 degrees | ||
| + | * the start angle within value is 10 degrees | ||
| + | * the stop angle within value is 10 degrees | ||
| + | <br><br> | ||
| + | ...how many degrees of bend will the mandrel be lubed? | ||
| + | <br><br> | ||
| + | Answer: 30 degrees<br><br> | ||
| + | Reason: The lube starts at 10 degrees and stops at 40 degrees (50 degrees - 10 degrees) | ||
| + | </td> | ||
| + | <td> | ||
</td> | </td> | ||
</tr> | </tr> | ||
</table> | </table> | ||
Revision as of 23:10, 30 December 2009
|
|
|
Contents |
Where is the Mandrel Lube Option?
|
The lube feature is only available inside the Bend Option cells of the FRB menu. This allows an operator to control mandrel lube for each bend.
|
|
Mandrel Lube Start and Stop
|
This feature works with the Mandrel Lube Start and Mandrel Lube Stop angle settings. These control the start and stop of the mandrel lube based upon the bend angle.
|
|
Press AutoBuild To Make the Changes Take Effect in CNC Processor
| Always press AutoBuild in the Bender Data menu for this change to take effect. |
|
Sample Settings and the Results
|
If...
|
