Difference between revisions of "Mandrel Lube"
(→Mandrel Lube Start and Stop) |
(→Mandrel Lube Start and Stop) |
||
| Line 55: | Line 55: | ||
For example, if you set the stop angle to 50 degrees on a 50 degree bend, then the mandrel lube '''will never start''' - because CNC Bender is told to stop the lube 50 degrees below the goal - which is 50 minus 50 = 0 degrees. | For example, if you set the stop angle to 50 degrees on a 50 degree bend, then the mandrel lube '''will never start''' - because CNC Bender is told to stop the lube 50 degrees below the goal - which is 50 minus 50 = 0 degrees. | ||
</td> | </td> | ||
| + | <td> | ||
| + | [[image:mandrellubesetstart.jpg|400px]]<br><br> | ||
| + | [[image:mandrellubesetstop.jpg|400px]] | ||
| + | </td> | ||
| + | </tr> | ||
| + | </table> | ||
| + | |||
| + | |||
| + | ==AUTOBUILD== | ||
| + | |||
| + | <table> | ||
| + | <tr> | ||
| + | <td width=300> | ||
| + | Always press AutoBuild in the Bender Data menu for this change to take effect.</td> | ||
<td> | <td> | ||
[[image:mandrellubesetstart.jpg|400px]]<br><br> | [[image:mandrellubesetstart.jpg|400px]]<br><br> | ||
Revision as of 22:57, 30 December 2009
|
|
|
Contents |
Where is the Mandrel Lube Option?
|
The lube feature is only available inside the Bend Option cells of the FRB menu. This allows an operator to control mandrel lube for each bend.
|
|
Mandrel Lube Start and Stop
|
This feature works with the Mandrel Lube Start and Mandrel Lube Stop angle settings. These control the start and stop of the mandrel lube based upon the bend angle.
|
|
AUTOBUILD
| Always press AutoBuild in the Bender Data menu for this change to take effect. |
|
