Difference between revisions of "Inspection Tolerances"
From ATTWiki
(→Setting a default tolerance) |
|||
Line 58: | Line 58: | ||
== Setting a default tolerance == | == Setting a default tolerance == | ||
+ | |||
+ | Once you have the default tolerance set for the part, save the project and the tolerances will be the same each time the part is loaded. | ||
+ | |||
+ | To set the default tolerances going forward for new projects, follow the steps in[https://www.advancedtubular.wiki/index.php/Change_the_VTube_Default_Setup Default Tolerances] | ||
==Other Pages== | ==Other Pages== |
Revision as of 15:27, 20 February 2023
|
Different Tolerances
The tolerances inside the Inspection Tab can be adjusted to qualify parts to different standards.
RadialThis value changes the tolerance the shape of the tube is qualified to. |
|
LinearThis value effects the ends of the tube.Change the value and press F2 on the keyboard or Refresh Parametrics in the upper right hand cornder of VTube |
|
AngularThis value effects the angle tolerance. These values can be adjusted independently. |
|
|