Difference between revisions of "VTube OMCG Bender Correction"
From ATTWiki
(→Network Protocol) |
(→OMCG Communications Protocol) |
||
| Line 30: | Line 30: | ||
</tr> | </tr> | ||
</table> | </table> | ||
| + | |||
| + | |||
| + | =Measuring System Interface= | ||
| + | <table width=1000> | ||
| + | <tr valign=top> | ||
| + | <td width=300> | ||
| + | Click on the Measuring System button in the toolbar to load the Measure System Interface. | ||
| + | </td> | ||
| + | <td width=300> | ||
| + | [[image:OMCGScreen_MeasuringSystemInterface_Window.png|700px]] | ||
| + | </td> | ||
| + | </tr> | ||
| + | </table> | ||
| + | |||
| + | |||
| + | |||
| + | |||
==Other Pages== | ==Other Pages== | ||
* See [[VTube-LASER]] | * See [[VTube-LASER]] | ||
* See [[VTube-STEP]] | * See [[VTube-STEP]] | ||
Revision as of 18:24, 14 February 2019
|
This page describes the use of the VTube-LASER to OMCG bender corrections. |
Back to VTube-LASER
Contents |
OMCG Communications Protocol
|
We worked with OMCG to add the Supravision Network protocol to their bender control software. This protocol is embedded in VTube-LASER. |
|
Measuring System Interface
|
Click on the Measuring System button in the toolbar to load the Measure System Interface. |
|
Other Pages
- See VTube-LASER
- See VTube-STEP
