Difference between revisions of "ROMER Certified Length Bar"

ROMER Certified Length Bar

• Back to VTube-LASER

Certified length bars are good for verifying that your arm is working properly.

The standard length bars use the 15mm calibration probe in one of three sockets.

There are three lengths available:

1. 305 mm
2. 711 mm
3. 1016 mm

For most customers using a 2.5 meter arm, the recommended length bar to purchase is the 711 mm.

Note: Certified length bars are not included as a STANDARD part of the ROMER Absolute Arm kit. They are strongly recommended. Try to have at least one length bar available in your shop.

The ROMER RDS system allows you to easily perform a quick check for the arm with the 15 mm hard probe installed.

The procedure is inside the RDS Control Panel - Probe menu.

Follow the steps to perform a length check.