Revision as of 20:43, 6 July 2007 (view source) Mcone (Talk | contribs) (→‎BENDER LIST: Which Controls Was This Installed On?) ← Older edit		Latest revision as of 20:48, 6 July 2007 (view source) Mcone (Talk | contribs) (→‎Which Benders Was This Version of CNC Bender Installed On?)
(One intermediate revision by one user not shown)
Line 30:		Line 30:
	<br>		<br>
−	=BENDER LIST: Which Benders Was This Version of CNC Bender Installed On?=	+	=Bender List=
	*SMT 19150 - Right Hand Electric MiiC Bender - Dual Radius Carriage Shifter		*SMT 19150 - Right Hand Electric MiiC Bender - Dual Radius Carriage Shifter
	*SMT 19152 - Right Hand Electric Eagle Bender - Single Radius		*SMT 19152 - Right Hand Electric Eagle Bender - Single Radius
	*SMT 20118 - Left Hand Eagle Bender - Dual Radius Head Shifter		*SMT 20118 - Left Hand Eagle Bender - Dual Radius Head Shifter

---

Latest revision as of 20:48, 6 July 2007

Contents 1 REVISION Information 2 NEW: Low Level Option - Don't Warn if Skip Run Buttons 3 ENHANCED: Support for All Eight Programmable Limit Switches 4 Bender List

REVISION Information

10-20070705, July 5, 2007

NEW: Low Level Option - Don't Warn if Skip Run Buttons

Experienced operators asked us to allow CNC Bender to warn when the SKIP RUN BUTTONS feature is enabled in the Pre-Bend Options page. This issue was addressed by inserting an Immediate Message warning and a Cycle Hold into the processlist if this condition exists.

If the option is ENABLED, then there is no warning if the Skip Run Buttons feature is enabled.

ENHANCED: Support for All Eight Programmable Limit Switches

CNC Bender can now support all eight Programmable Limit Switches for any motion-controlled axis.

Bender List

• SMT 19150 - Right Hand Electric MiiC Bender - Dual Radius Carriage Shifter
• SMT 19152 - Right Hand Electric Eagle Bender - Single Radius
• SMT 20118 - Left Hand Eagle Bender - Dual Radius Head Shifter