Difference between revisions of "VTube-LASER Cut Planes"
From ATTWiki
(→How to Create a Cut Plane) |
(→STEP 1) |
||
Line 32: | Line 32: | ||
In VTube-LASER click on Measure Process, then click on Measure Cut Plane. The Laser scanner will turn off automatically.</td> | In VTube-LASER click on Measure Process, then click on Measure Cut Plane. The Laser scanner will turn off automatically.</td> | ||
<td> | <td> | ||
− | [[image:vtube- | + | [[image:vtube-laser_cutplane_step1.png|400px]] |
</td> | </td> | ||
</tr> | </tr> | ||
<tr> | <tr> | ||
<td width=300> | <td width=300> | ||
+ | |||
===STEP 2=== | ===STEP 2=== | ||
Press Probe Setup and Calibration.</td> | Press Probe Setup and Calibration.</td> |
Revision as of 21:55, 4 September 2015
|
About Cut Planes
Cut planes allow VTube-LASER to define a plane of a table or other surface in order to cut laser points from being used in measurements to VTube-LASER.
How to Create a Cut Plane
Cut planes are created with four measurements with the ball probe.
STEP 1In VTube-LASER click on Measure Process, then click on Measure Cut Plane. The Laser scanner will turn off automatically. |
|
STEP 2Press Probe Setup and Calibration. |
|
STEP 3Select the correct ball probe then press OK. |
|
STEP 4Press the Close button in the FARO Arm Utilities window. |
|
STEP 5Observe that the new ball probe selection will appear in the Arm grid. |
Other Pages
- Back to the VTube-LASER page