Difference between revisions of "VTube-LASER Cut Planes"
From ATTWiki
(→How to Change the Default Ball Probe Setup) |
(→How to Create a Cut Plane) |
||
Line 20: | Line 20: | ||
==How to Create a Cut Plane== | ==How to Create a Cut Plane== | ||
− | + | Cut planes are created with four measurements with the ball probe. | |
+ | |||
+ | [[image:cutplane_1234.png|right]] | ||
<table> | <table> |
Revision as of 21:30, 4 September 2015
|
About Cut Planes
Cut planes allow VTube-LASER to define a plane of a table or other surface in order to cut laser points from being used in measurements to VTube-LASER.
How to Create a Cut Plane
Cut planes are created with four measurements with the ball probe.
STEP 1In VTube-LASER click on Measure Process, then click on Measure Cut Plane. The Laser scanner will turn off automatically. |
|
STEP 2Press Probe Setup and Calibration. |
|
STEP 3Select the correct ball probe then press OK. |
|
STEP 4Press the Close button in the FARO Arm Utilities window. |
|
STEP 5Observe that the new ball probe selection will appear in the Arm grid. |
Other Pages
- Back to the VTube-LASER page