Difference between revisions of "Output Sustain in Seconds"

From ATTWiki
Jump to: navigation, search
Line 1: Line 1:
−
[[Image:Cnclite lowlevel processor.jpg|thumb|Test]]
+
[[Image:Cnclite lowlevel processor.jpg|thumb|CNC Bender Lite - PROCESSOR Tab of Low Level Menu]]
  
  

Revision as of 19:52, 11 January 2007

CNC Bender Lite - PROCESSOR Tab of Low Level Menu


This is a LOW LEVEL variable in CNC Bender that allows you to set the sustain time for the output module that keeps the bender running.

The default value is 10 seconds. But in some cases, it may be necessary to set this value higher if other processes require too much CPU time to service this output module within 10 seconds. This may be the situation when building a very large process list in CNC Bender Lite software while the bender is running.



Advanced Optimization Ideas

Be sure all axes are tuned properly.

  1. Use I2T HMI software for setting PID values so that motion is smooth and yet precise.

    2. image:Cnclite lowlevel processor.jpg


Be sure all axes and actuators are travelling at maximum sustainable speed.

  1. This requires monitoring the output voltages of the axis controllers. (Use the I2T HMI software to monitor output voltages.)

  2. When running at speed 10, is the voltage at 80-90% of the maximum?


See also Bend Program Optimization

--Mcone 10:32, 20 July 2006 (EDT)

Retrieved from "http://www.advancedtubular.wiki/index.php?title=Output_Sustain_in_Seconds&oldid=2140"