Difference between revisions of "VTube-LASER v1.75.1"
From ATTWiki
| Line 35: | Line 35: | ||
There were circumstances where VTube would backup too many steps during a remeasure. This has been repaired. | There were circumstances where VTube would backup too many steps during a remeasure. This has been repaired. | ||
</td> | </td> | ||
| + | <td width=300> | ||
| + | </td> | ||
| + | </tr> | ||
| + | </table> | ||
| + | |||
| + | ===[[image:Check.jpg|25px]] ENHANCED: Removed the Default Radius Setup Message=== | ||
| + | |||
| + | <table cellpadding=10> | ||
| + | <tr valign=top> | ||
| + | <td width=300> | ||
| + | The message that says that VTube will automatically set the default radius to 1.5 times the diameter no longer displays as it serves no useful purpose.</td> | ||
<td width=300> | <td width=300> | ||
</td> | </td> | ||
Latest revision as of 18:08, 3 February 2012
|
Revision 1.75.1Back to VTube-LASER |
|
ENHANCEMENT: Added Page Numbers to Reports in Print Preview
|
VTube now shows the date, time, and page numbers at the bottom of print preview reports. |
|
FIX: Previous Move During Remeasure
|
There were circumstances where VTube would backup too many steps during a remeasure. This has been repaired. |
ENHANCED: Removed the Default Radius Setup Message
| The message that says that VTube will automatically set the default radius to 1.5 times the diameter no longer displays as it serves no useful purpose. |
Other Pages
- Back to VTube-LASER
