Difference between revisions of "Change the default linear units in VTube"
From ATTWiki
| Line 4: | Line 4: | ||
[[image:vtube-step_logo.jpg|200px]]<br> | [[image:vtube-step_logo.jpg|200px]]<br> | ||
[[image:vtube-laser_logo.jpg|200px]] | [[image:vtube-laser_logo.jpg|200px]] | ||
| − | |||
* Back to [[VTube-STEP]] | * Back to [[VTube-STEP]] | ||
* Back to [[VTube-LASER]] | * Back to [[VTube-LASER]] | ||
Revision as of 13:44, 25 May 2011
|
|
|
Steps to changing the default linear units
| Use the toolbar buttons to clear VTube and press the Linear Units button until the correct units are active. |
|
| Press the System Options button. |
|
| Press the Project Setup tab, and then press the Set Project Default State button. |
|
|
Exit the System Options menu. VTube will now clear to the new linear unit. |
Other Pages
- Back to the VTube page
