Difference between revisions of "Change the default linear units in VTube"
From ATTWiki
| Line 35: | Line 35: | ||
</td> | </td> | ||
</tr> | </tr> | ||
| + | <tr> | ||
| + | <td width=300> | ||
| + | Press the Project Setup tab, and then press the Set Project Default State button.</td> | ||
| + | <td> | ||
| + | [[image:vtube-step_setprojdefaultstate.jpg|300px]] | ||
| + | </td> | ||
| + | </tr> | ||
| + | |||
</table> | </table> | ||
<br> | <br> | ||
Revision as of 13:42, 25 May 2011
|
Revision 1.65
|
|
Steps to changing the default linear units
| Use the toolbar buttons to clear VTube and press the Linear Units button until the correct units are active. |
|
| Press the System Options button. |
|
| Press the Project Setup tab, and then press the Set Project Default State button. |
|
Other Pages
- Back to the VTube page
