Difference between revisions of "DOCS2Addison Benderlink"
From ATTWiki
(→SETUP Screen) |
|||
| Line 19: | Line 19: | ||
==SETUP Screen == | ==SETUP Screen == | ||
| − | + | <table> | |
| − | [[image:docs2addison_mainscreen_setup.jpg| | + | <tr> |
| + | <td width=400>This is where all setup occurs in Benderlink. Up to 100 benders can be programmed and '''remembered'' in this Benderlink. <br><br> | ||
| + | </td> | ||
| + | <td>[[image:docs2addison_mainscreen_setup.jpg|400px]]</td> | ||
| + | </tr> | ||
| + | <tr> | ||
| + | <td width=300>[[image:addison_databend.jpg|200px]] | ||
| + | </td> | ||
| + | <td>[[image:romer_infinite.jpg|200px]]</td> | ||
| + | </tr> | ||
| + | |||
| + | </table> | ||
==RUN Screen== | ==RUN Screen== | ||
Revision as of 03:48, 30 July 2010
| DOCS2Addison Benderlink is software is designed to allow the AddisonMckee to communicate with the DOCS-based measuring center. |
 |
|
 |
SETUP Screen
| This is where all setup occurs in Benderlink. Up to 100 benders can be programmed and 'remembered in this Benderlink. |
 |
|
|
|
RUN Screen
This is the screen where Benderlinking occurs. Choose the bender number in the Setup screen, then switch to RUN.
This is the RUN screen:
Other Pages
- Back to Benderlink
