Difference between revisions of "Mandrel Lube"
(→Mandrel Lube Start and Stop) |
(→Mandrel Lube Start and Stop) |
||
| Line 53: | Line 53: | ||
The stop angle refers to where the lube zone ends: The value is an angle that is subtracted from the FINAL ANGLE.<br> | The stop angle refers to where the lube zone ends: The value is an angle that is subtracted from the FINAL ANGLE.<br> | ||
<br> | <br> | ||
| − | For example, if you set | + | For example, if you set the stop angle to 50 degrees on a 50 degree bend, then the mandrel lube '''will never start''' - because CNC Bender is told to stop the lube 50 degrees below the goal - which is 0 degrees. |
</td> | </td> | ||
<td> | <td> | ||
Revision as of 22:55, 30 December 2009
|
|
|
Contents |
Where is the Mandrel Lube Option?
|
The lube feature is only available inside the Bend Option cells of the FRB menu. This allows an operator to control mandrel lube for each bend.
|
|
Mandrel Lube Start and Stop
|
This feature works with the Mandrel Lube Start and Mandrel Lube Stop angle settings. These control the start and stop of the mandrel lube based upon the bend angle.
|
|
