Difference between revisions of "Modicon Momentum"
(→I2T IFC220E Servo Modules) |
|||
| Line 20: | Line 20: | ||
<tr> | <tr> | ||
<td width="200"> | <td width="200"> | ||
| − | This is the form for the I2T servo modules. You can see a slight difference on the base from the INPUT module | + | This is the form for the I2T servo modules. You can see a slight difference on the base from the INPUT module with the RJ-45 receptacle. |
</td> | </td> | ||
<td> | <td> | ||
| Line 29: | Line 29: | ||
<tr> | <tr> | ||
<td width="200"> | <td width="200"> | ||
| − | In the I2T servo modules, the serial port is an RJ-45 receptacle port shown in this image. | + | In the I2T servo modules, the serial port is an RJ-45 receptacle port shown in this image. INPUT and OUTPUT modules don't include this port. |
</td> | </td> | ||
<td> | <td> | ||
| Line 37: | Line 37: | ||
</table> | </table> | ||
| − | |||
| − | |||
==INPUT Base with Ethernet Communication Adapter== | ==INPUT Base with Ethernet Communication Adapter== | ||
Revision as of 12:31, 23 December 2009
Contents |
About the Modicon Momemtum Package
This the form of the modules that are installed to machines that use our CNC Bender software. The different modules come in a variety of functions - but the same packaging. For example, the image above shows an INPUT base with 32-points with an Ethernet Communications Adapter clipped on the top.
See this data sheet (16 pages) for an overview of these modules.
View the Modicon Momentum I/O Base User Guide (662 pages).
They mount to DIN rails in electrical panels.
I2T IFC220E Servo Modules
The I2T (Pronounced "I Square T") servo modules use the same package form as the other Modicon products. They contain a computer that can control 2 axes.
|
This is the form for the I2T servo modules. You can see a slight difference on the base from the INPUT module with the RJ-45 receptacle. |
|
|
In the I2T servo modules, the serial port is an RJ-45 receptacle port shown in this image. INPUT and OUTPUT modules don't include this port. |
|
INPUT Base with Ethernet Communication Adapter
This is an Ethernet Communications Adapter on top of a 32-point INPUT base.
BACK of Modicon Momentum I/O Base
This is the back of the base.
Other Pages
- Back to CNC Bender page
- Back to CNC Bender General Information page
- Back to CNC Bender Technical Notes page
