Difference between revisions of "Feed Axis Faults During Feed Bending"
From ATTWiki
| Line 8: | Line 8: | ||
</td> | </td> | ||
<td> | <td> | ||
| − | [[image:cncbender_toolpage_radius.jpg| | + | [[image:cncbender_toolpage_radius.jpg|550px]] |
</td> | </td> | ||
</tr> | </tr> | ||
Revision as of 20:19, 15 July 2009
During Feed-Bending it is possible to experience a Feed Axis Fault that is most often caused by one of two issues:
|
TOOL PAGE: The Centerline Radius values do not to match the bend die radii on the bender. |
|
- TOOL PAGE: The Feed Axis Adjust % is not set to the proper value in the Tool page.
If the Feed Axis faults especially on large angle bends, then one or both of these are probably an issue.
