Difference between revisions of "Wiring: Power to Mitsubishi RESET pin when E-Stop"
From ATTWiki
(→Wire Jump) |
(→Wire Jump) |
||
| Line 2: | Line 2: | ||
This wiring scheme may not exist on older SMT benders. The wiring allows for power to run to the RESET pin on the Mitsubishi drive whenever the Master Power and Safety Relay Contactors are deenergized. This clears the Mitsubishi drives of any faults. | This wiring scheme may not exist on older SMT benders. The wiring allows for power to run to the RESET pin on the Mitsubishi drive whenever the Master Power and Safety Relay Contactors are deenergized. This clears the Mitsubishi drives of any faults. | ||
| − | ==Wire Jump== | + | ==STEP 1: Wire Jump== |
Wire jump point 22 in M-1 to point 22 in M-2<br> | Wire jump point 22 in M-1 to point 22 in M-2<br> | ||
Revision as of 23:53, 24 June 2009
Contents |
About
This wiring scheme may not exist on older SMT benders. The wiring allows for power to run to the RESET pin on the Mitsubishi drive whenever the Master Power and Safety Relay Contactors are deenergized. This clears the Mitsubishi drives of any faults.
STEP 1: Wire Jump
Wire jump point 22 in M-1 to point 22 in M-2
llll
Other Pages
- Back to the CNC Bender Page
- Back to the CNC Bender Technical Notes Page
