Mcone at 17:14, 3 April 2007

2007-04-03T17:14:50Z

New page

This [[Dynamic Option]] allows operators to enable a custom [[COMDEF]] (Command Definition) before either the [[Load Position]] or the [[Start Position]] moves in the [[Process List]] for bending. Use this feature to enable/disable [[actuators]] just before either of these moves occur in the [[Process List]].

===User-Definable and therefore Flexible===
Because these reference general [[COMDEF]] files ('''PreCommand_LoadPosition''' and '''PreCommand_StartPosition''') the motion or action that these PreCommands perform can be adjusted to fit the application by anyone familiar with using the [[COMDEF.exe]] and [[CIO.exe]] programs.

For example, it would take only a few minutes to reconfigure CNC Bender to actuate several new outputs, then watch for any number of inputs in either of these [[COMDEF]] commands. '''''No new programming from Advanced Tubular is required to adjust these commands.'''''

[[image:Cncbender_option_precommand2.jpg|550px]]

<table cellpadding="15" width = 550>

<tr valign="top">
<td bgcolor="#abbad1" width=150>
PreCommand Load Position
---- 
Enable / Disable
</td>
<td bgcolor="#e3e4f5">
[[image:Cncbender_option_precommand.jpg]]

Enable this option to insert the PreCommand_LoadPosition COMDEF in the process list immediately before the Feed axis move to Load position command is issued in the list.
 
The PreCommand_LoadPosition command can be modified to activate/deactivate custom actuators immediately before the carriage is moved to the Load position.

</td>
</tr>

<tr valign="top">
<td bgcolor="#abbad1" width=150>
PreCommand Start Position
---- 
Enable / Disable
</td>
<td bgcolor="#e3e4f5">
[[image:Cncbender_option_precommand3.jpg]]

Enable this option to insert the PreCommand_StartPosition COMDEF in the process list immediately before the Feed axis move to Start position command is issued in the list.
 
The PreCommand_StartPosition command can be modified to activate/deactivate custom actuators immediately before the carriage is moved to the Start position.

</td>
</tr>
</table>

PreCommand for Load and Start - Revision history

Mcone at 17:14, 3 April 2007