View source for CNC Bender v11-20091201

<table>
<tr>
<td width=300>
[[image:Cncbender_logo_pushbending.png]]
<br>

<table>
<tr>
<td>
Type of Upgrade: '''FLEXIBILITY'''
</td>
<td>
The changes in this version are changes to CNC Bender for better flexibility.
</td>
</tr>
</table>

</td>
<td>
[[image:Operatorstation_model.jpg]]
</td>
</tr>
</table>

__NOTOC__


===[[image:Check.jpg|25px]] NEW- Logic Allows Push Buttons to Toggle States===
<table>
<tr valign=top>
<td width=300>
* CNC Bender now allows logic to make a physical momentary push-button into a toggle switch.  For example, push the button to switch a state on, then push it again to switch the state off.<br><br>

* For example, it is possible to use logic in the Constant Run processlist to switch a End Cycle ON and OFF using a push button.<br><br>
* It is also possible to illuminate the button according to the current End Cycle state.
<br><br>
[[image:redmomentarypushbutton.jpg|100px]]
</td>

<td>
[[image:remoteoperatorstation_toggle_endcycle.jpg|400px]]
</td>
</tr>

</table>

<br><br>

===[[image:Check.jpg|25px]] NEW- Editor for High Speed Constant Run Processlist===
<table>
<tr valign=top>
<td width=300>
* The new editor in Low Level allows you to edit the new High Speed Constant Run Processlist.<br><br>
<br><br>

<br>

</td>

<td>
[[image:highspeed_constantrun_processlist.jpg|400px]]
</td>
</tr>

</table>

<br><br>

===[[image:Check.jpg|25px]] NEW- Better Warning for Missing Processlists===
<table>
<tr valign=top>
<td width=300>
* Messages now display for missing High Speed Constant Run Processlist<br><br>
</td>

<td>
[[image:warning_missing_processlist_file.jpg|400px]]
</td>
</tr>

</table>

===[[image:Check.jpg|25px]] UPDATE- Improved Grids in Dynamic Option Lists ===
<table>
<tr valign=top>
<td width=300>
* New grid source with improvements for better performance.
</td>
<td width=300>
[[image:optionslists.jpg|400px]]
</td>
</tr>

</table>

<br><br>

===[[image:Check.jpg|25px]] REPAIR- Counter in RunPage is Updated to Zero When Run is Complete===

<table>

<tr valign=top>
<td width=300>
* The part count updated normally except when the Runlist Run is complete.  This is corrected.
</td>

<td width=450>
[[image:runpage_counter.jpg|450px]] <br><br>
</td>

</tr>
</table>

<br><br>

=Other Pages=
*Back to [[CNC Bender]]
*Back to [[CNC Bender Software Updates]]
*See [[CNC Bender v11-20091104]]
*See [[CNC Bender General Information]]
*See [[Absolute Rotate]]
*See [[Absolute Rotate Offset Position]]
*See [[Final Feed Clearance]]
*See [[Mandrel Retract]]
*See [[Mandrel Retract Part Release]]